background
x
loader
Troubleshooting
arrow By ATA By Message Color By Observed Faults by MDCBy Tips

Select color for CAS message that you wish to troubleshoot

(WARNING)
RED MESSAGE (CAUTION)
AMBER MESSAGE (ADVISORY)
CYAN MESSAGE (STATUS)
WHITE MESSAGE Require immediate crew attention. These messages are accompanied by flashing master warning, triple chime attenson with or without voice message or dedicated tone. Require immediate crew awareness and future crew action may be required in the form of alternate system selection or performance limitation. These message are accompanied by flashing master caution and a single chime. Indicate safe or normal system operation which require crew awareness, over and above the dark cockpit philosophy. Indicate minor failures or reduction in systems capability, which require no crew action.

This page includes :

For AOG assistance contact:

CRC Montreal (YUL)
Quick Links

01/28/21

Message Overview:

R ENG FUEL TEMP LOW
(Advisory)

DDG Reference: None
Pilot Action (QRH): ENG 05-23
System Description: 73-30-00
Schematic Diagram: 73-21-00
Wiring Diagram: 73-31-01

Message Description:

The cyan 'R ENG FUEL TEMP LOW' advisory CAS message indicates the fuel temperature in the engine filter housing is low.

  • The engine computer constantly monitors the fuel temperature from the FHOC. The temperature sensor (RTD) communicates the fuel temperature entering the filter to the ECU. The fuel temperature measurement is for event logging and indication of icing conditions below -40.7°, until -40.3°.

Possible Causes:

  • None

Troubleshooting Tips:

Advisory Wire/Service Bulletin: None

Forum Articles/Infoservice/Newsletter: None

Quick Links:

None

Troubleshooting Recommendations:

  1. Interrogate the MDC as follows:

    1. On the cursor control panel, ensure the toggle switch is to the right and select Anti-Ice, ECS and Fuel buttons simultaneously. The MDC main menu should now be displayed on Display Unit #3.
    2. Using the joystick, select Current Faults (if the fault is active) or Aircraft History to research stored faults. From Aircraft History you can then select Fault Message History and locate the air condition fault logged.
    3. Select the MDC fault from the drop down below to provide additional information to assist in troubleshooting.

MCID codes can be entered also, these codes are embedded in the MDC system under each equation ID # and will be displayed either way.

Registered and/or unregistered trademarks of Bombardier Inc. or its subsidiaries. © 2015 Bombardier Inc. All rights reserved.