background
x
loader
Troubleshooting
arrow By ATA By Message Color By Observed Faults by MDCBy Tips

Select color for CAS message that you wish to troubleshoot

(WARNING)
RED MESSAGE (CAUTION)
AMBER MESSAGE (ADVISORY)
CYAN MESSAGE (STATUS)
WHITE MESSAGE Require immediate crew attention. These messages are accompanied by flashing master warning, triple chime attenson with or without voice message or dedicated tone. Require immediate crew awareness and future crew action may be required in the form of alternate system selection or performance limitation. These message are accompanied by flashing master caution and a single chime. Indicate safe or normal system operation which require crew awareness, over and above the dark cockpit philosophy. Indicate minor failures or reduction in systems capability, which require no crew action.

This page includes :

For AOG assistance contact:

CRC Montreal (YUL)
Quick Links

03/10/21

Message Overview:

Message Name:

MLGDNLK CCRK51 OVLD FAULT

Message Code:

B3-006650

Associated CAS:

None

Reporting LRU: CCR-K51; MLGDNLK
System Description: 32-60-00
Schematic Diagram: 32-61-00
Wiring Diagram: 32-31-01
32-61-09

Message Description:

Proximity Sensor Electronic Unit detects an overload condition on the discrete output to the Completion Center Relay (CCR) K51.

Possible Causes:

  • Junction Box 4 (JB4) Circuit-Card 2 (JB4-DB2)
  • Completion Center Relay (CCR) (K51)
  • Proximity Sensor-Electronic Unit (PSEU) (A9)
  • Associated Wiring

Troubleshooting Tips:

Advisory Wire/Service Bulletin: None

Forum Articles/Infoservice/Newsletter: None

Quick Links:

Removal of the Junction Box JB2 Circuit-Cards AMM 24-63-05-000-802
Installation of the Junction Box JB2 Circuit-Cards AMM 24-63-05-400-802
Operational Test of Junction Box JB4 Card 2 AMM 24-63-13-710-802
Removal of the Proximity−Sensor Electronic Unit (PSEU) AMM 32-61-09-000-801
Installation of the Proximity−Sensor Electronic Unit (PSEU) AMM 32-61-09-400-801
Functional Test of the Proximity−Sensor Electronic Unit (PSEU) AMM 32-61-09-720-801
Standard Practices - Replace Wiring SPM 20-12-00-02
Standard Practices - Wire Repair SPM 20-12-10-02

Troubleshooting Recommendations:

  1. Do wiring check from the JB4-DB2 connector JB4EP1 Pin 20 to the PSEU connector A9AP1 Pin 1K. Repair as required.

    1. If system checks are good, do close out.
    2. If fault remains, continue with next step.

  2. Replace the Circuit Board 2 of the Junction Box 4.

    1. If system checks are good, do close out.
    2. If fault remains, continue with next step.

  3. Replace the PSEU.
  4. Do close out.

Registered and/or unregistered trademarks of Bombardier Inc. or its subsidiaries. © 2015 Bombardier Inc. All rights reserved.