background
x
loader
Troubleshooting
arrow By ATA By Message Color By Observed Faults by MDCBy Tips

Select color for CAS message that you wish to troubleshoot

(WARNING)
RED MESSAGE (CAUTION)
AMBER MESSAGE (ADVISORY)
CYAN MESSAGE (STATUS)
WHITE MESSAGE Require immediate crew attention. These messages are accompanied by flashing master warning, triple chime attenson with or without voice message or dedicated tone. Require immediate crew awareness and future crew action may be required in the form of alternate system selection or performance limitation. These message are accompanied by flashing master caution and a single chime. Indicate safe or normal system operation which require crew awareness, over and above the dark cockpit philosophy. Indicate minor failures or reduction in systems capability, which require no crew action.

This page includes :

For AOG assistance contact:

CRC Montreal (YUL)
Quick Links

04/06/21

Message Overview:

Message Name:

NO R-IRS-4 BUS INPUT

Message Code:

B3-661641

Associated CAS:

None

Reporting LRU: SVC
System Description: 34-00-00
Schematic Diagram: 34-34-00
Wiring Diagram: 34-34-01

Message Description:

No R-IRS-4 data is received at SVC but is not reported failed at SATCOM.

Possible Causes:

  • Synthetic Vision Computer (SVC) (A230)
  • Junction Box (JB2)
  • Associated Wiring

Troubleshooting Tips:

Advisory Wire/Service Bulletin: None

Forum Articles/Infoservice/Newsletter: None

NOTE: A GPS signal input is required for the SVS image to show on the pilot and the co-pilot primary flight display (PFD).

Quick Links:

Removal of the Junction Box JB2 AMM 24-63-05-000-803
Installation of the Junction Box JB2 AMM 24-63-05-400-803
Removal of the Synthetic Vision Computer (SVC) AMM 34-34-01-000-801
Removal of the Synthetic Vision Computer (SVC) AMM 34-34-01-400-801
Standard Practices - Replace Wiring SPM 20-12-00-02
Standard Practices - Repair Wiring SPM 20-12-10-02

Troubleshooting Recommendations:

  1. Reset SVS (CB2-A7) circuit breakers.

    1. If system checks are good, do close out.
    2. If fault remains, continue with next step.

  2. Do wiring check of the ARINC 429 data bus R-IRS-4 from SVC connector A230AP1 to Junction Box 2 connector JB2EP1 or respective Test Points. Repair/replace as required.

    1. If system check passes, do close out.
    2. If fault remains, continue with next step.

  3. Replace SVC.

    1. If system checks passes, do close out.
    2. If fault remains, continue with next step.

  4. Replace Junction Box 2.
  5. Do close out.

Registered and/or unregistered trademarks of Bombardier Inc. or its subsidiaries. © 2015 Bombardier Inc. All rights reserved.