Message Name:

R CH B RVDT OUT OF RANGE

Message Code:

B3-006800

Associated CAS:

FLT SPOILERS FAULT
(Caution)

The Spoiler Electronic Control Unit #2 (SECU2) has detected Flight Spoiler Control Lever (FSCL) RVDT 4 out of range.

• Flight Spoiler Control Lever (FSCL) RVDT 4
• Spoiler Electronic Control Unit (SECU) #2 (A119)
• Associated Wiring

Advisory Wire/Service Bulletin:

• AW300-27-0037 - Spoiler Electronic Control Unit (SECU) - Circuit Breaker Reset Procedure (20501 - 20999)

Forum Articles/Infoservice/Newsletter: None

• Reset SECU1 circuit breaker 'SPOILER CTRL 1' CBP1-B9 if any of the inboard MFS and GS #2, #4, #5 and #7 surface indication are amber or magenta.
• Reset SECU2 circuit breaker 'SPOILER CTRL 2' CBP2-B9 if any of the inboard MFS and GS #1, #3, #6 and #8 surface indication are amber or magenta.

NOTE:It is not permissible to cycle the SECU 1 or 2 circuit breakers in the air.

1. Re-rig SECU 2.
2. Visually inspect the back of the box for pin damage or in the rack. If damaged, repair pin.
3. Swap SECU 1 with SECU 2. If problem follows, replace SECU 2.
   NOTE: Perform electronic rigging of both SECUs when either SECU is swapped or replaced. The intent is if a SECU that is being installed was previously rigged in a different location in the same aircraft or it is being installed in a different aircraft or the SECU is a spare part it requires electronic rigging (AMM 27-61-05-820-802) per the instructions in AMM TASK 27-61-05-400-801 Installation of the Spoiler Electronic-Control Unit (SECU).
4. Check wiring from FSCL RVDT 3 to SECU 2. If damaged, repair wiring.
5. Check FSCL RVDT 4 coil resistance.

   1. Remove SECU 2 and locate connector A119AP1.
   2. Pin 2J to 1F = 90Ω ±5%.
   3. Pin 2K to 1F = 90Ω ±5%.
   4. Pin 7K to 7J = 197Ω ±5%.
   5. If coil resistances are out of tolerance, then replace FSCL.