background
x
loader
Troubleshooting
arrow By ATA By Message Color By Observed Faults by MDCBy Tips

Select color for CAS message that you wish to troubleshoot

(WARNING)
RED MESSAGE (CAUTION)
AMBER MESSAGE (ADVISORY)
CYAN MESSAGE (STATUS)
WHITE MESSAGE Require immediate crew attention. These messages are accompanied by flashing master warning, triple chime attenson with or without voice message or dedicated tone. Require immediate crew awareness and future crew action may be required in the form of alternate system selection or performance limitation. These message are accompanied by flashing master caution and a single chime. Indicate safe or normal system operation which require crew awareness, over and above the dark cockpit philosophy. Indicate minor failures or reduction in systems capability, which require no crew action.

This page includes :

For AOG assistance contact:

CRC Montreal (YUL)
Quick Links

03/24/21

Message Overview:

Message Name:

NO TA/RA-2 BUS IN

Message Code:

B3-007

Associated CAS:

None

Reporting LRU: MFD 2
System Description: 31-61-00
Schematic Diagram: 31-61-00
Wiring Diagram: 31-61-04
34-43-01

Message Description:

TSS data bus (TA/RA-2) is reported absent by the right MFD, while the right IOC does not receive right PFD data.

Possible Causes:

  • Adaptive Flight-Display Unit 'A429 Input' (R MFD) (A28)
  • Adaptive Flight-Display Unit (R PFD) (A26)
  • Junction Box 1 (JB1)
  • Traffic/Collision Avoidance System (TCAS) and Traffic Surveillance System (TSS) Transponder (A238)
  • Associated Wiring

Troubleshooting Tips:

Advisory Wire/Service Bulletin: None

Forum Articles/Infoservice/Newsletter: None

Quick Links:

Removal of the Junction Box JB1 AMM 24-63-01-000-802
Installation of the Junction Box JB1 AMM 24-63-01-400-802
Removal of the Adaptive Flight-Display Unit AMM 31-61-01-000-801
Installation of the Adaptive Flight-Display Unit AMM 31-61-01-400-801
Removal of the Traffic/Collision Avoidance System (TCAS) and Surveillance System Transponder Unit (TSS) AMM 34-43-03-000-801
Installation of the Traffic/Collision Avoidance System (TCAS) and Surveillance System Transponder Unit (TSS) AMM 34-43-03-400-801
Wiring - Maintenance Practices - ALL SPM 20-12-00-02
Wire Repair - Maintenance Practices - ALL SPM 20-12-10-02
Electrical Connectors - Maintenance Practices - ALL SPM 20-20-00-02

Troubleshooting Recommendations:

  1. Confirm all switches on the reversion select panel are selected to NORM.
  2. Reset R MFD Circuit Breaker CB2-C5 and R PFD Circuit Breaker CB2-C3. Is the fault message still present?

    1. If NO, do close out.
    2. If YES, continue with next step.

  3. Interchange R MFD (A28) with L MFD (A29). Is the fault message still present?

    1. If NO, do close out.
    2. If YES, continue with next step.

  4. Interchange R PFD (A26) with L PFD (A27). Is the fault message still present?

    1. If NO, do close out.
    2. If YES, continue with next step.

  5. Do wiring check between R MFD (A28), through JB1, and R PFD (A26) for the following wires:

    From: To: Result:
    Conn. A28P2 - 84 Conn. A26P2 - 84
    Conn. A28P2 - 85 Conn. A26P2 - 85

    1. If the check is not satisfactory, repair defective wiring or replace defective JB1.
    2. If the check is satisfactory, continue with next step.

  6. Do wiring check between R MFD (A28), through JB1, and TSS (A238) for the following wires:

    From: To: Result:
    Conn. A28P2 - 84 Conn. A238EP1 - E1
    Conn. A28P2 - 85 Conn. A238EP1 - F1

    1. If the check is not satisfactory, repair defective wiring or replace defective JB1.
    2. If the check is satisfactory, replace TSS (A238).

  7. Do close out.

Registered and/or unregistered trademarks of Bombardier Inc. or its subsidiaries. © 2015 Bombardier Inc. All rights reserved.