background
x
loader
Troubleshooting
arrow By ATA By Message Color By Observed Faults by MDCBy Tips

Select color for CAS message that you wish to troubleshoot

(WARNING)
RED MESSAGE (CAUTION)
AMBER MESSAGE (ADVISORY)
CYAN MESSAGE (STATUS)
WHITE MESSAGE Require immediate crew attention. These messages are accompanied by flashing master warning, triple chime attenson with or without voice message or dedicated tone. Require immediate crew awareness and future crew action may be required in the form of alternate system selection or performance limitation. These message are accompanied by flashing master caution and a single chime. Indicate safe or normal system operation which require crew awareness, over and above the dark cockpit philosophy. Indicate minor failures or reduction in systems capability, which require no crew action.

This page includes :

For AOG assistance contact:

CRC Montreal (YUL)
Quick Links

04/02/21

Message Overview:

Message Name:

NO PFD TERR-2 BUS INPUT

Message Code:

B3-642550

Associated CAS:

None

Reporting LRU: TAWS MARK V
System Description: 34-42-00
Schematic Diagram: 34-42-00
Wiring Diagram: 34-42-01

Message Description:

TERR-2 (453) bus not received at R-PFD.

Possible Causes:

  • Terrain-Avoidance Warning System Computer (TAWS) (A34)
  • Right Primary Flight Display (R PFD) (A26)
  • Right Multi-Function Display (R MFD) (A28)
  • Associated Wiring

Troubleshooting Tips:

Advisory Wire/Service Bulletin: None

Forum Articles/Infoservice/Newsletter: None

Quick Links:

Removal of the Adaptive Flight-Display Unit AMM 31-61-01-000-801
Installation of the Adaptive Flight-Display Unit AMM 31-61-01-400-801
Standard Practices - Replace Wiring SPM 20-12-00-02
Standard Practices - Repair Wiring SPM 20-12-10-02

Troubleshooting Recommendations:

  1. Reset TAWS (CB2-A6) circuit breaker or push in the TAWS TEST/RESET Switch on the center pedestal.

    1. If system check passes, do close out.
    2. If fault remains, continue with next step.

  2. Do the wiring check of the ARINC 453 data bus TERR-2 between TAWS computer connector A34AP1 to the R PFD connector A26P1. Repair/replace as required.

    1. If system check passes, do close out.
    2. If fault remains, continue with next step.
      NOTE: An internal short of any LRUs connected to this data bus might cause this failure.

  3. Do the wiring check of the ARINC 453 data bus TERR-2 between R PFD connector A26P1 and R MFD connector A28P1. Repair/replace as required.

    1. If system check passes, do close out.
    2. If fault remains, continue with next step.
      NOTE: An internal short of any LRUs connected to this data bus might cause this failure.

  4. Swap PFDs.

    1. If system check passes, do close out.
    2. If fault remains, continue with next step.

  5. Swap MFDs.

    1. If system check passes, do close out.
    2. If fault remains, continue with next step.

  6. Replace the TAWS computer.
  7. Do close out.

Registered and/or unregistered trademarks of Bombardier Inc. or its subsidiaries. © 2015 Bombardier Inc. All rights reserved.