background
x
loader
Troubleshooting
arrow By ATA By Message Color By Observed Faults By CAIMS By Tips

Select color for CAS message that you wish to troubleshoot

(WARNING)
RED MESSAGE (CAUTION)
AMBER MESSAGE (ADVISORY)
CYAN MESSAGE (STATUS)
WHITE MESSAGE Require immediate crew attention. These messages are accompanied by flashing master warning, triple chime attenson with or without voice message or dedicated tone. Require immediate crew awareness and future crew action may be required in the form of alternate system selection or performance limitation. These message are accompanied by flashing master caution and a single chime. Indicate safe or normal system operation which require crew awareness, over and above the dark cockpit philosophy. Indicate minor failures or reduction in systems capability, which require no crew action.

This page includes :

For AOG assistance contact:

CRC Montreal (YUL)
Quick Links

04/28/20

Message Overview:

Fault Message:

ADLU SATCOM FAULT

Fault Code:

2320009TDY

Associated CAS:

None

Reporting LRU: Airborne Data-Link Unit
System Description: 23-23-00
Schematic Diagram: 23-23-00 [ Global Express ]  [ G5000 ]  [ Global XRS ]
Wiring Diagram: 23-23-01 [ Global Express ]  [ G5000 ]  [ Global XRS ]
23-23-02 [ Global Express ]  [ G5000 ]  [ Global XRS ]

Fault Description:

Satellite Communication System (SATCOM) ARINC 429 broadcast data not received by Airborne Data-Link Unit (ADLU). Set when no data is received for 1 minute and cleared when data is received.

Possible Causes:

  • Airborne Data-Link Unit (ADLU) (A239)
  • Satellite Communication System (SATCOM)
  • Associated Wiring

Troubleshooting Tips:

Advisory Wire/Service Bulletin:

AW 700-23-0584 - Honeywell SDU-600 Obsolescence

AW 700-23-0756 - MCS-7000 Obsolescence

SB 700-23-001 - Modification MCS-6000 SATCOM

SB 700-23-043 - Modification MCS-7000 SATCOM

Forum Articles/Infoservice/Newsletter: None

This fault can be seen if SATCOM is not logged on to a satellite, which could happen when the aircraft is in the hanger.

Make sure the aircraft is out of hangar before proceeding with further troubleshooting steps.

NOTE: If no SATCOM is installed, disregard the fault code.

Quick Links:

Operational Test of the Satellite Communication System AMM 23-13-00-710-801 [ Global Express ]  [ G5000 ]  [ Global XRS ]
Removal of the Airborne Data-Link Unit AMM 23-23-01-000-801 [ Global Express ]  [ G5000 ]  [ Global XRS ]
Installation of the Airborne Data-Link Unit AMM 23-23-01-400-801 [ Global Express ]  [ G5000 ]  [ Global XRS ]
Wire Repair - Maintenance Practices - ALL SPM 20-12-10-02 [ Global Express ]  [ G5000 ]  [ Global XRS ]

Troubleshooting Recommendations:

  1. Do the operational test of the SATCOM system. Is the operational test of the SATCOM system satisfactory?

    1. If NO, troubleshoot and fix the SATCOM system as required, and then continue with next step.
    2. If YES, continue with next step.

  2. Operate the Airborne Data-Link System using SATCOM network to receive the terminal text weather information. Is the NEW message advisory shown on FMS CDU and new message received?
    NOTE: Do the initialization of the Flight Management System.

    1. If YES, verify that CAIMS fault code 2320009TDY 'ADLU SATCOM FAULT' is not displayed on PMAT and do close out.
    2. If NO, continue with next step.

  3. Perform wiring checks, short to ground and pin/socket retention checks between the ADLU connector A239AP1 and the SDU connector A228BP1. Is it satisfactory?

    1. If NO, repair or replace the defective wiring as required and do close out.
    2. If YES, continue with next step.

  4. Replace the Airborne Data-Link Unit (ADLU).
    NOTE: The ADLU does not receive ARINC broadcast data, when SATCOM/SDU is operational.
  5. Do close out.

Registered and/or unregistered trademarks of Bombardier Inc. or its subsidiaries. © 2015 Bombardier Inc. All rights reserved.