CONFIG SLAT/FLAP
(Warning)

When the slats are not in the out position and/or the flaps are not in the 6 degrees or 16 degrees position during take-off roll.

• Incorrect position of Slat and Flap
• Slat/Flap Control Lever
• Slat Flap Control Unit.
• Data Acquisition Unit
• Associated Wiring

Advisory Wire/Service Bulletin: None

Forum Articles/Infoservice/Newsletter: None

The CONFIG SLAT/FLAP (Warning) CAS message is posted when the A/C is Weight-On-Wheel and the Throttle Quadrant is at set in Take-Off condition. If the slats and flaps can be selected OUT/6 or 16°, bring them there and confirm the message clear.

NOTE: 700-1A11-27-022 (9279-9304) and 700-27-059 (9159-9304) - Modifications to permit zero flap Take-Off capability with full performance" will prevent having this CAS message with the slats OUT and the Flaps at 0°

This message will normally be posted with the "NO TAKEOFF" Advisory CAS message and other warning CAS messages. If you have this condition, continue the troubleshooting with the CAS message "NO TAKEOFF" to isolate the condition. Otherwise continue this procedure.

A system failure that prevents the slat/flap control system from going to the correct position for slat/flap selector handle detents 6 degrees or 16 degrees also shows this message. If you have this condition, continue the troubleshooting with the other Slat/ Flap CAS message to isolate the fault.