08/20/19
Message Overview:
Fault Message:
ARINC FAULT/EVSHC/WRG
Fault Code:
3000143IN
Associated CAS:
| Reporting LRU: | Enhanced Vision System Heater Controller (EVSHC) |
| System Description: | 34-33-00 |
| Schematic Diagram: | 34-41-00 [ Global Express ] [ G5000 ] [ Global XRS ] |
| Wiring Diagram: | 34-33-03 [ Global Express ] [ G5000 ] [ Global XRS ] |
Fault Description:
The Enhanced Vision System Heater Controller (EVSHC) does not receive ARINC labels 211 (TAT), 203 (Alt) and 040 (WOW).
Possible Causes:
- Data Acquisition Unit (DAU) 2 (A18)
- Enhanced Vision System Heater Controller (EVSHC) (A315)
- Junction Box 4 (JB4)
- Associated Wiring
Troubleshooting Tips:
Advisory Wire/Service Bulletin: None
Forum Articles/Infoservice/Newsletter: None
Quick Links:
| Removal of the Junction Box JB4 | AMM 24-00-05-000-801 [ Global Express ] [ G5000 ] [ Global XRS ] |
| Installation of the Junction Box JB4 | AMM 24-00-05-400-801 [ Global Express ] [ G5000 ] [ Global XRS ] |
| Removal of the Data Acquisition Units (DAU) | AMM 31-42-01-000-801 [ Global Express ] [ G5000 ] [ Global XRS ] |
| Installation of the Data Acquisition Units (DAU) | AMM 31-42-01-400-801 [ Global Express ] [ G5000 ] [ Global XRS ] |
| Removal of the Enhanced Vision System (EVS) Heater Controller |
AMM 34-33-09-000-801 [ Global Express ] [ G5000 ] [ Global XRS ] |
| Installation of the Enhanced Vision System (EVS) Heater Controller |
AMM 34-33-09-400-801 [ Global Express ] [ G5000 ] [ Global XRS ] |
| Wire Repair - Maintenance Practices - ALL | SPM 20-12-10-02 [ Global Express ] [ G5000 ] [ Global XRS ] |
Troubleshooting Recommendations:
- Perform wiring checks between JB4, DAU 2 and EVSHC.
- If wiring checks are not good, repair defective wiring as required and do close out.
- If wiring checks are good, continue with next step.
- Swap DAU 2 with DAU 4.
- If system checks are good, replace DAU 2 and do close out.
- If fault remains, continue with next step.
- Replace EVSHC.
- If system checks are good, do close out.
- If fault remains, continue with next step.
- Replace JB4.
- Do close out.