background
x
loader
Troubleshooting
arrow By ATA By Message Color By Observed Faults By CAIMS By Tips

Select color for CAS message that you wish to troubleshoot

(WARNING)
RED MESSAGE (CAUTION)
AMBER MESSAGE (ADVISORY)
CYAN MESSAGE (STATUS)
WHITE MESSAGE Require immediate crew attention. These messages are accompanied by flashing master warning, triple chime attenson with or without voice message or dedicated tone. Require immediate crew awareness and future crew action may be required in the form of alternate system selection or performance limitation. These message are accompanied by flashing master caution and a single chime. Indicate safe or normal system operation which require crew awareness, over and above the dark cockpit philosophy. Indicate minor failures or reduction in systems capability, which require no crew action.

This page includes :

For AOG assistance contact:

CRC Montreal (YUL)
Quick Links

08/28/19

Message Overview:

Fault Message:

SPCB/WRG/HUDC MON FAULT

Fault Code:

343001CHUD

Associated CAS:

None

Reporting LRU: Head-Up Display (HUD) Computer
System Description: 34-32-00
Schematic Diagram: 34-32-00 [ Global Express ]  [ G5000 ]  [ Global XRS ]
Wiring Diagram: 27-32-05 [ Global Express ]  [ G5000 ]  [ Global XRS ]
34-32-04 [ Global Express ]  [ G5000 ]  [ Global XRS ]

Fault Description:

Head-Up Display System (HUD) does not receive data from the Stall Protection Computer (SPC).

Possible Causes:

  • Head-Up-Display (HUD) Computer (A250)
  • Stall Protection Computer (SPC) (A40)
  • Associated Wiring

Troubleshooting Tips:

Advisory Wire/Service Bulletin: None

Forum Articles/Infoservice/Newsletter: None

If more fault reports are sent by a different system about the SPC, do the fault isolation of the stall protection computer.

Quick Links:

Removal of the Stall Protection Computer AMM 27-32-01-000-801 [ Global Express ]  [ G5000 ]  [ Global XRS ]
Installation of the Stall Protection Computer AMM 27-32-01-400-801 [ Global Express ]  [ G5000 ]  [ Global XRS ]
Removal of the Head-Up-Display (HUD) Computer AMM 34-32-01-000-801 [ Global Express ]  [ G5000 ]  [ Global XRS ]
Installation of the Head-Up-Display (HUD) Computer AMM 34-32-01-400-801 [ Global Express ]  [ G5000 ]  [ Global XRS ]
Wire Repair - Maintenance Practices - ALL SPM 20-12-10-02 [ Global Express ]  [ G5000 ]  [ Global XRS ]

Troubleshooting Recommendations:

  1. Perform wiring check between SPC and HUDC as follow:

    From To Result
    A40BP1-35 A250EP1-J4
    A40BP1-48 A250EP1-K4
    GND A250EP1-J3
    A40BP1- SH A250EP1-SH

    1. If wiring checks are not good, repair defective wiring as required and do close out.
    2. If wiring checks are good, continue with next step.
      NOTE: When short circuit is detected, remove all interface components and reinstall one at a time to isolate short.

  2. Replace SPCs.

    1. If system checks are good, do close out.
    2. If fault remains, continue with next step.

  3. Replace HUDC.
  4. Do close out.

Registered and/or unregistered trademarks of Bombardier Inc. or its subsidiaries. © 2015 Bombardier Inc. All rights reserved.