09/06/19
Message Overview:
Fault Message:
IRS/WRG/WX RTA FAULT (33B)
Fault Code:
3440026WX
Associated CAS:
| Reporting LRU: | Weather Radar System |
| System Description: | 34-41-00 |
| Schematic Diagram: | 34-41-00 [ Global Express ] [ G5000 ] [ Global XRS ] |
| Wiring Diagram: | 34-41-01 [ Global Express ] [ G5000 ] [ Global XRS ] 34-45-01 [ Global Express ] [ G5000 ] [ Global XRS ] 34-45-02 [ Global Express ] [ G5000 ] [ Global XRS ] |
Fault Description:
Weather Radar Transceiver (RTA) has detected incorrect altitude data from either Inertial Reference Unit (IRU). Amber FAIL legend and fault code 33 show in Multi-Function Display (MFD) status window. Crew may notice ALT mode is unavailable.
Possible Causes:
- Inertial Reference Unit (IRU) 1 (A32)
- Inertial Reference Unit (IRU) 2 (A33)
- Weather Radar (WXR) Receiver/Transmitter (R/T) (A125)
- Associated Wiring
Troubleshooting Tips:
Advisory Wire/Service Bulletin: None
Forum Articles/Infoservice/Newsletter: None
The FAIL legend and fault codes show on the MFD status window only when the WXR system is in TST (Test) mode and an active fault has occurred.
NOTE:
- RTA uses first IRU that provides valid data. If RTA detects failure of attitude data from one IRU, it will switch to the other source
- There is a delay of up to 4 minutes for some faults to display. Therefore allow system in test mode for significant time to display all active faults
Quick Links:
| Removal of the Weather Radar Receiver/Transmitter | AMM 34-41-01-000-801 [ Global Express ] [ G5000 ] [ Global XRS ] |
| Installation of the Weather Radar Receiver/Transmitter | AMM 34-41-01-400-801 [ Global Express ] [ G5000 ] [ Global XRS ] |
| Removal of the Inertial Reference Units (IRU) | AMM 34-45-01-000-801 [ Global Express ] [ G5000 ] [ Global XRS ] |
| Installation of the Inertial Reference Units (IRU) | AMM 34-45-01-400-801 [ Global Express ] [ G5000 ] [ Global XRS ] |
| Wire Repair - Maintenance Practices - ALL | SPM 20-12-10-02 [ Global Express ] [ G5000 ] [ Global XRS ] |
Troubleshooting Recommendations:
- Make sure that IRUs were aligned on ATT mode prior to TST.
- Perform a wiring check for open or short circuit to ground between WX RTA (A125P1), IRU 1 (A32BP1), and IRU 2 (A33BP1).
- If wiring checks are not good, repair defective wiring as required and do close out.
- If wiring checks are good, continue with next step.
- Power IRUs one at a time and monitor code 33B to determine defective IRU. (The suspected IRU does not remove code 33B).
- If system checks are good, do close out.
- If fault remains, continue with next step.
- Replace defective IRUs.
- If system checks are good, do close out.
- If fault remains, continue with next step.
NOTE: Use IRU 3 for swapping if spare IRU is not available.
- Replace WXR R/T.
- Do close out.