07/15/19
Message Overview:
Fault Message:
LH AFT XFER PUMP/PRESS SW/WRG
Fault Code:
2844623PK
Associated CAS:
| Reporting LRU: | Fuel Management and Quantity Gauging Computer (FMQGC) |
| System Description: | 28-22-00 |
| Schematic Diagram: | 28-22-00 [ Global Express ] [ G5000 ] [ Global XRS ] |
| Wiring Diagram: | 28-22-02 [ Global Express ] [ G5000 ] [ Global XRS ] |
Fault Description:
L AFT XFER PMP/PRES SWITCH/WRG FAULT shows when:
- Left AFT Transfer-Pump is commanded ON
- Left AFT Transfer-Pump Pressure Switch status is low
- Electrical Management System Control Display Unit (EMS CDU) has not failed
OR
- Left AFT Transfer-Pump is commanded OFF
- Left AFT Transfer-Pump Pressure Switch status is high
- EMS CDU has not failed
Possible Causes:
- Left AFT Transfer Pump (B34)
- Left AFT Transfer-Pump Pressure-Switch (S22)
- Fuel Management and Quantity Gauging Computer (FMQGC) (A47)
- Associated Wiring
Troubleshooting Tips:
Advisory Wire/Service Bulletin:
- AW700-45-0065 - CAIMS Nuisance Fault Messages
Forum Articles/Infoservice/Newsletter: None
Quick Links:
| Removal of the Aft Transfer Pumps | AMM 28-22-25-000-801 [ Global Express ] [ G5000 ] [ Global XRS ] |
| Installation of the Aft Transfer Pumps | AMM 28-22-25-400-801 [ Global Express ] [ G5000 ] [ Global XRS ] |
| Removal of the Aft Transfer-Pump Pressure-Switches | AMM 28-22-29-000-801 [ Global Express ] [ G5000 ] [ Global XRS ] |
| Installation of the Aft Transfer-Pump Pressure-Switches | AMM 28-22-29-400-801 [ Global Express ] [ G5000 ] [ Global XRS ] |
| Removal of the Computer | AMM 28-41-01-000-801 [ Global Express ] [ G5000 ] [ Global XRS ] |
| Installation of the Computer | AMM 28-41-01-400-801 [ Global Express ] [ G5000 ] [ Global XRS ] |
| Wire Repair - Maintenance Practices - ALL | SPM 20-12-10-02 [ Global Express ] [ G5000 ] [ Global XRS ] |
Troubleshooting Recommendations:
- If the message is present while the transfer pump is set to 'OFF', continue with next step. If message is present while transfer pump is set to 'ON', go to step 3.
- With A/C power off and fuel system unpressurized, perform a continuity check on FMQGC connector A47AP1-E14.
- If there is continuity to ground on pin E14, investigate wiring interface and/or replace pressure switch and do close out.
- If there is no continuity to ground, continue with next step.
- Swap the left aft transfer pump pressure switch with the right aft transfer pump pressure switch. Is the fault still present?
- If NO, replace left aft transfer pump pressure switch.
- If YES, continue with next step.
- Make sure the left aft transfer occurs when the pump is set top 'ON'.
- If fuel transfer does not occur, investigate the fuel pump.
- If fuel transfer occurs, continue with next step.
- Remove the FMQGC and re-install it, making sure it is properly and fully inserted into place. Is the fault still present?
- If NO, do close out.
- If YES, continue with next step.
- Replace the FMQGC.
- Do close out.