background
x
loader
Troubleshooting
arrow By ATA By Message Color By Observed Faults By CAIMS By Tips

Select color for CAS message that you wish to troubleshoot

(WARNING)
RED MESSAGE (CAUTION)
AMBER MESSAGE (ADVISORY)
CYAN MESSAGE (STATUS)
WHITE MESSAGE Require immediate crew attention. These messages are accompanied by flashing master warning, triple chime attenson with or without voice message or dedicated tone. Require immediate crew awareness and future crew action may be required in the form of alternate system selection or performance limitation. These message are accompanied by flashing master caution and a single chime. Indicate safe or normal system operation which require crew awareness, over and above the dark cockpit philosophy. Indicate minor failures or reduction in systems capability, which require no crew action.

This page includes :

For AOG assistance contact:

CRC Montreal (YUL)
Quick Links

09/12/19

Message Overview:

Fault Message:

R OUTBD/INBD WAIT SNSR INSTALLATION

Fault Code:

3616419BMC

Associated CAS:

R BLEED FAULT
(Advisory)

Reporting LRU: Bleed Management Controller (BMC) 2
System Description: 30-12-00
Schematic Diagram: 30-11-00 [ Global Express ]  [ G5000 ]  [ Global XRS ]
Wiring Diagram: 30-11-02 [ Global Express ]  [ G5000 ]  [ Global XRS ]

Message Description:

A Right Wing Leading-Edge Over-Temperature condition is detected by the Outboard Wing Anti-Ice Temperature Sensor (WAITS) (Temperature > 133 °C).

Possible Causes:

  • Right Inboard Anti-Icing Temperature Sensor (E41)
  • Right Outboard Anti-Icing Temperature Sensor (E40)

Troubleshooting Tips:

Advisory Wire/Service Bulletin: None

Forum Articles/Infoservice/Newsletter: None

Quick Links:

Removal of the Anti-Icing Temperature Sensors AMM 30-11-05-000-801 [ Global Express ]  [ G5000 ]  [ Global XRS ]
Installation of the Anti-Icing Temperature Sensors AMM 30-11-05-400-801 [ Global Express ]  [ G5000 ]  [ Global XRS ]
Anti-Icing Temperature Sensors AIPC 30-11-05 [ Global Express ]  [ G5000 ]  [ Global XRS ]

Troubleshooting Recommendations:

  1. Verify installation of right OUTBD WAITS as per AMM and reinstall if it is out of tolerance.

    1. If system checks are good, do close out.
    2. If fault remains, continue with next step.

  2. Verify installation of right INBD WAITS as per AMM and reinstall if it is out of tolerance.
  3. Do close out.

Registered and/or unregistered trademarks of Bombardier Inc. or its subsidiaries. © 2015 Bombardier Inc. All rights reserved.